Location

MWA Technology
MWA Technology Limited, Offices & Workshop,
2 Wharton Street Ind. Est., Birmingham, West Midlands, B7 5TR

+44 (0) 121 327 7771

X
Detection from MWA Technology

Detection

P30 3 Zone Gas Detection

P30
P30 3 Zone Gas Detection available at MWA Technology
MWA Technology

P30 3 Zone Gas Detection

P30
Enquire

The P30 gas detection electronic control centre is used for the detection of gas within industrial environments. Natural gas, town gas, LPG and cylinder gas can be detected using the various sensors available. This unit will provide gas detection for three separate zones.

Key Features

  • Visual LED indication for three separate zones
  • Internal audible alarm
  • Adjustable alarm time delay
  • IP40 protection
  • Wall or panel front mounting
  • Insulated enclosure
  • Two SPDT relays for use of closing the gas solenoid valve and BMS alarms
  • Alarm delay setting – up to 60 seconds
  • Complies with CEI EN 60730-1 standards
  • 230v 50Hz or 12vDc
Top

Make an Enquiry

Please leave this field empty.

Ceiling Mounted Presence detector

RC-IR24-PC
Ceiling Mounted Presence detector available at MWA Technology
Regin

Ceiling Mounted Presence detector

RC-IR24-PC
Enquire

IR24-PC is a 360° presence detector for automatic ventilation control of HVAC systems. It uses infrared light. The detector has a potential-free change-over relay for activation/deactivation of for instance a fan-coil controller. It saves money and gives higher comfort in premises requiring forced ventilation for shorter periods of time, such as conference rooms, assembly-halls etc. The unit can be ceiling mounted, providing a 360° detection pattern with a maximum range of 10.5m

  • 24 V AC/DC supply voltage
  • Potential-free, change-over relay
  • Individually settable ON- and OFF-delays
  • 360° detection
  • Unobtrusive design
 MWA Code  Detection  voltage  class  Temp. Range
RC-IR24-PC  H 2.5m, 25° angle  24 V AC  IP20  -20…+50°C

 

Top

Make an Enquiry

Please leave this field empty.

Detection Heads

Detection Heads available at MWA Technology
MWA Technology

Detection Heads

Enquire

These gas sensor heads are to be used with either P30 or P82 gas detection units. There are two types available, the S81 for natural gas and light gas, the S82 for LPG heavy gases. The sensor for alarm is set below the L.E.L level (Lower Explosion Limit) however there is internal regulation for the sensitivity if required.

Key Features

  • Green LED for power on indication
  • Red LED for gas presence indication
  • Amber LED for fault indication
  • Anti-shock casing material
  • IP54
Top

Make an Enquiry

Please leave this field empty.

EGS gas detector

EGS\NG - CL
EGS gas detector available at MWA Technology
Electro Controls

EGS gas detector

EGS\NG - CL
Enquire

This range of gas detectors can be used to detect leaks and provide an alarm in general commercial and industrial applications.
Can be used stand alone, with a BMS system or with a monitor panel.

MWA Code Gas Range Relay set point
EGS-NG Nat Gas ( methane) 0 to 5,000ppm 2500ppm
EGS-LPG LP Gas 0 to 2,000ppm 1000ppm
EGS-CO Carbon monoxide 0 to 100ppm 30ppm
EGS-R134 Refrig R134 0 to 1000ppm 500ppm
EGS-H Hydrogen 0 to 2,000ppm 1000ppm
EGS-CO2/IR Carbon dioxide 0 to 10,000ppm 5000ppm
ECS-OZ Ozone 0-1ppm 0.2ppm
EGS-O Oxygen 0 to 25% 19%
EGS-H2S Hydrogen sulphide 0 to 30ppm 5ppm
EGS-SD Sulphur dioxide 0 to 10ppm 2ppm
EGS-ND Nitrogen dioxide 0 to 10ppm 3ppm
EGS-CL Chlorine 0 to 10ppm 0.5ppm
Top

Make an Enquiry

Please leave this field empty.

P60 Stand Alone Gas Detector

P60 Stand Alone Gas Detector available at MWA Technology
MWA Technology

P60 Stand Alone Gas Detector

Enquire

A high sensitivity sensor for the detection of gas concentration. The stand alone gas detector is available in two models. P60 for use on natural gas detection and the P60 used for LPG and cylinder liquid gas.

Key Features

  • Pre-alarm LED signal when below the L.E.L
  • Internal audible alarm
  • Automatic gas solenoid valve shut off
  • Continual sensor diagnostic tests
  • Fault indication
  • Mute override for 10 minutes
  • Insulated shock resistant enclosure
  • Complies with UNI CEI 70028 standards
  • IMQ homologation
  • 230v 50Hz
Top

Make an Enquiry

Please leave this field empty.

P82 4 Zone Gas Detection

P82
P82 4 Zone Gas Detection available at MWA Technology
MWA Technology

P82 4 Zone Gas Detection

P82
Enquire

The P82 gas detection electronic control centre is used for the detection of gas within industrial environments. Natural gas, town gas, LPG and cylinder gas can be detected using the various sensors available.

  • Visual LED indication for four separate zones
  • Internal audible alarm
  • Adjustable alarm time delay
  • Din Mounting
  • Insulated enclosure
  • Two SPDT relays for use of closing the gas solenoid valve and BMS alarms
  • Alarm delay setting – up to 60 seconds
  • Complies with CEI EN 60730-1 standards
  • 230v 50Hz
Top

Make an Enquiry

Please leave this field empty.

S&S Merlin CT500 gas detection

CT500
S&S Merlin CT500 gas detection available at MWA Technology
S&S Northern

S&S Merlin CT500 gas detection

CT500
Enquire

The key operated CT500 is UK manufactured and like all S & S Northern products carries a 3 Year warranty and is fully supported by our technical team. The CT500 has a fascia
mounted emergency shut off button fitted as standard and the fascia mounted LEDs give simple and concise information to the operator.

The panel is fully compatible with S & S Northern remote emergency stop terminals allowing a large number of emergency terminals to be connected in series and wired back to the panel.

Top

Make an Enquiry

Please leave this field empty.

S&S Merlin FAB1 gas detection

FAB1
S&S Merlin FAB1 gas detection available at MWA Technology
S&S Northern

S&S Merlin FAB1 gas detection

FAB1
Enquire

With prior notice to a fire alarm test, the operator can turn the spring loaded key to the on position giving an un-interrupted gas supply for between 10 and 45 minutes.

During this time the system controlling the gas will ignore shut-off signals from the buildings fire alarm system and allow factors such as heating systems to remain operational.

Top

Make an Enquiry

Please leave this field empty.

Wall Mounted Presence detector

RC-IR24-P
Wall Mounted Presence detector available at MWA Technology
Regin

Wall Mounted Presence detector

RC-IR24-P
Enquire

IR24-P is a presence detector designed for automatic ventilation control of HVAC systems. It uses infrared light. The detector has a potential-free change-over relay for activation/deactivation of for instance a fan-coil controller. It saves money and gives higher comfort in premises requiring forced ventilation for shorter periods of time, such as conference rooms, assembly-halls etc. The unit can be wall or corner mounted with a 110°, 15m detection range.

  •  24 V AC/DC supply voltage
  • Potential-free, change-over relay
  • Individually settable ON- and OFF-delays
 MWA Code  Detection  voltage  class  Temp. Range
RC-IR24-P  15 x 15 m, 110° angle  24 V AC  IP20  -20…+50°C

 

Top

Make an Enquiry

Please leave this field empty.

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close